The mills is rubber products factory not less equipment, in the process of using the mill may lead to misuse of some faults, such as the emergence of more problems can be directly linked to factory maintenance, small fault slightly we can self repair. Here in Guangdong to take advantage of the king to remind everyone in the maintenance of their own refining machine please note the following 3 aspects
1, remove the transmission gear
Note that the corresponding meshing teeth of a set of gears should be marked on the assembly, the assembly is also installed according to the position of the original meshing teeth, in order to avoid the expansion of the gear meshing gear drive noise.
2, open mill roller surface grinding, in order to meet the requirements of the work, as far as possible not too much to reduce the size of the working face diameter, in order to avoid the end of the roller gear meshing interference phenomenon.
3, gear meshing tooth wear, if serious, can be put on the mill gear turning 180 degrees after the assembly, let the other noise of meshing involute gear tooth surface meshing of the gear can reduce the gear.
Guangdong take the king to remind everyone to maintain their own work to open the machine must pay attention to cut off the power supply, safety first. In order to avoid accidents.