The laboratory flat vulcanizing machine is specially used in the laboratory and the research institute to make the test piece. The utility model has the advantages that the tubular electric heating element is heated, the boiler is not needed, the air pollution is reduced, the workshop is clean, the operation is convenient, and the utility model is safe and reliable. Can also be used as a small amount of production, the experimental equipment is one of the selected products of the majority of institutions of higher learning.
The operating rules of the flat plate vulcanizing machine are as follows:
1 before the experiment, check whether the fuel tank to achieve the required scale, and then check whether the components are working properly, the column (frame) is the lubrication
2 preheat the attention of the hot plate temperature, such as not up to the requirements, must be under the guidance of the instructor to adjust, is strictly prohibited to tamper with
3 the mold should be placed between the hot plate to prevent burns or injury accident, it is forbidden to take up the mold when the flat plate or cleaning debris
4 in the mold should be placed in the middle of the plate, the person to stand in the center of the operating table, after the mold to meet the requirements of the pressure, the closure of the motor, to less than the requirements must ask the teacher to adjust, can not be allowed to tamper with
5 mould to prevent broken hook, hand feeding die wear gloves to prevent burns, in case of mold products sticking mold, mold tapping tool on hand to prevent mold beware, landing or injured foot
6 take the test piece in the mold, pay attention to the mold cavity and the mold surface smooth surface, the protection prevents scratches
7 the machine malfunction, the power must be cut off immediately, and report to the teacher, is strictly prohibited without permission remove components, crush mold, processing is strictly prohibited without permission
8 according to the size of the mold and the provisions of the unit pressure adjustment pressure gauge, non pressure vulcanization
9 after the end of the experiment to cut off the power supply, cleaning, put down the pressure, close the oil valve