Mixer work, two rotor relative rotation, the material from the feed inlet will be clamped into the gap by extrusion and shear rotor, rubber mixing machine manufacturers through the gap after the hit top to sharp edge is divided into two parts, respectively along the wall and go back to the room before and after the rotor gap between the roll gap on the side.
In a week around the rotor flow, shear and friction materials are everywhere, the compound rapid temperature rise, reduced viscosity increased with the wetting agent in the rubber surface, the rubber and compound full contact surface. The complexing agent is connected with the rubber material through the gap between the rotor and the rotor, the rotor is connected with the upper and the lower crown, and the inner wall of the interior wall is sheared and broken.