The operation flow of the general vulcanizing machine is as follows:
1, before the operation, check whether the fuel tank to achieve the required scale, and then check whether the components are working properly, the column (frame) is the lubrication.
2, pay attention to the temperature of the hot plate, if not meet the requirements, must be under the guidance of the teacher's guidance, is strictly prohibited.
3, the mold placed between the hot plate should prevent burns or injury accident, not in the hot plate when the mold.
4, in the mold should be placed in the middle of the plate, the person should stand in the center of the operating table. After closing the mold to meet the requirements of the pressure, turn off the motor, not up to the requirements of the guidance of teachers should be adjusted, not allowed to tamper with.
5, take the mold to prevent pressure hook, hand injury. In case of sticky products mold mold, mold tapping tool on hand to prevent mold beware, landing or injured foot.
6, the machine failure, must immediately cut off the power supply, and report to the teacher, is strictly prohibited to disassemble the parts. Crush mold processing, is strictly prohibited without permission.
7, cut off the power after the end of the experiment, cleaning, fill in the use of records.
8, product bulk density, iron pollution is minimal.
9, the structure is novel and unique, simple and reasonable, stable operation.
10, production operations, the formation of stone to protect the bottom, the fuselage without wear, durable.
11, through the non broken material ability is strong, the material moisture content is small, high moisture content.
12, the main bearing with thin oil station lubrication cycle, there is a standby pump, to ensure continuous supply to the main engine, automatic control and accident alarm can be achieved.
Operating equipment must be carried out according to the operating instructions, not in violation of relevant regulations, safety first.