The mixer is used for mixing equipment rubber in rubber products factory is an indispensable equipment in the use of mixer process such as failure is usually notice mixer manufacturers to come to repair, such as some small faults we can solve, without mixer manufacturer personnel.
What problems can we do it ourselves?
1, the mixer between the coil and the moving coil contact surface uneven, can not form a sealed oil film
We can remove the mixer fixed ring check, drag the contact surface without injury, while the contact rate is low, the need to run, the running time is more than 4-8h, the contact surface can not be broken when running oil
2, close to the motor cycle, fixed between the hard particles, strain contact surface, so that the contact surface can not form a sealed oil film
If it is a moving coil was injured, the need to repair the grinding stone, grinding need special equipment. The structure is divided into two halves. Fixed ring plane grinding moving coil and good will, the fixed ring is assembled, the slow grinding hours, grinding lubricant
3, mixing motor alloy ring off, you can then set to replace the coil, coil number running hours, can be solved