The mills is no less equipment rubber products factory, in the process of using mill may misoperation resulting in some problems, such as the emergence of big questions can directly contact the manufacturer for repair, the subtle small problems we can repair itself. Here we suggest Baoding precision instruments in their own repair mill please must note the following three aspects.
1, open transmission gear
Pay attention to a set of gear meshing teeth to do the corresponding symbol, the device also according to the original meshing gear device, in order to prevent the drive gear meshing transmission noise.
2, open mill roller working surface grinding, in order to be able to meet the requirements of the job, as far as possible not too much to reduce the size of the working surface diameter, in order to prevent the end of the roller gear meshing interference phenomenon.
3, gear meshing tooth wear, if severe, can put this on the mills are turning 180 degrees after the gear meshing transmission device, the noise made another involute gear tooth surface meshing of the gear can reduce the gear.
Baoding precision instruments to remind ourselves to repair the mill must pay attention to disconnect the power supply, safety first. Avoid accidents.