The mixer is used for mixing equipment rubber in rubber products factory is an indispensable equipment in the use of mixer process such as failure is usually notice mixer manufacturers to come to repair, such as some small faults we can solve, do not have to wait for the mixer manufacturer, so to reduce the cost of time.

What can we do it?

1, the mixer between the coil and the moving coil contact surface uneven, can not form a sealed oil film

We can remove the mixer fixed ring check, drag the contact surface without injury, while the contact rate is low, the need to run, the running time is more than 4-8h, the contact surface can not be broken when running oil

2, close to the motor cycle, fixed between the hard particles, strain contact surface, so that the contact surface can not form a sealed oil film

If it is a moving coil was injured, the need to repair the grinding stone, grinding need special equipment. The structure is divided into two halves. Fixed ring plane grinding moving coil and good will, the fixed ring is assembled, the slow grinding hours, grinding lubricant

3, the integration of motor ring alloy off

You can then set to replace the coil, coil number running hours, can be solved

Reminder：

If your mixer equipment failure, be sure to check the cause of the fault, as far as possible please professional maintenance, do not disassemble!